Sensoray 7429 Manual do Utilizador Página 30

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 48
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 29
Calibrate Board
This command is used to calibrate all 7429 internal standards. All measurements made
by the coprocessor are referenced to these standards. To perform a board calibration,
you must supply two reference voltages (5 volts and 500 millivolts) and one reference
resistance (380 ohms).
References must be calibrated in the following order: 5 volts, 500 mV, and 380 ohms.
COMMAND: (224 + CHAN),(CAL CODE),(DATA HIGH),(DATA LOW)
RESPONSE: (GARBAGE)
Cal Code Reference
0 5 volts
1 500 mV
2 380 ohms
Example: This code segment will assist you in calibrating the 7429.
FOR calCode% = 0 to 2
SELECT CASE calCode%'setup cal parameters
CASE 0
refName$ = "5 volt"
scalar% = 5000
sensorCode% = 0
CASE 1
refName$ = "500 mV"
scalar% = 50
sensorCode% = 13
CASE 2
refName$ = "380 ohm"
scalar% = 40
sensorCode% = 9
END SELECT
INPUT "What channel is "; refName$; " reference connected to"; chan%
CALL SendByte (16 + chan%)'declare channel sensor type
CALL SendByte (sensorCode%)
INPUT "What is exact value of "; refName$; " reference"; actualValue!
CALL SendByte (224 + chan%)'issue calibrate command
CALL SendByte (calCode%)
CALL SendWord (actualValue! * scalar%)
junk% = ReadByte%'wait for 7429 to calibrate
OUT BasePort% + 1, 0'reset 7429 board
Vista de página 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Comentários a estes Manuais

Sem comentários